Arduino Motor Shield 4 Channel L293D H-Bridge Dc Motor Control Support PWM

Description

Flux L293D Shield can use DC motors and power supplies of up to 36 Volts, can supply a maximum current of 600mA per channel, the L293D chip is also a H-Bridge.

– 2 interface for 5V Servo connected to for Arduino’s high-resolution dedicated timer.
– Can drive 4 DC motors or 2 stepper motors or 2 Servo
– Up to 4 bi-directional DC motors with individual 8-bit speed selection
– Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
– 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 36V DC
– Pull down resistors keep motors disabled during power-up
– Reset Button
– 2 external terminal power interface, for seperate logic/motor supplies
– Tested compatible for Arduino UNO, Mega, Diecimila & Duemilanove