Description

Instruction:

1. Before connecting the battery, connect the charging head of the mobile phone through the type-c data cable, and check that the four lights turn on in turn to confirm that the module chip functions well.

2. Use a multimeter to measure the prepared battery voltage, and ensure that the battery voltage is between 3.0-4.2V. If the voltage is higher or lower than this range, the battery may fail or is not applicable to the battery type.

3. After ensuring that the battery is free of problems, do a good job of static protection, prepare thick wires for welding, pay attention to the positive and negative electrodes, and the reverse plate must be burned.

4. The charging input can be connected to the charging head through the type-c interface, or it can be connected to 5V through the interface marked in blue in the figure above. The input current of port C should be greater than the input current of the welding interface (the input battery terminal of port C can be charged by 3A, and the maximum input battery terminal of the welding interface is 2A).

PRODUCT DESCRIPTION:

3.1A synchronous boost conversion output
3A battery terminal synchronization switch charging
Support filling while placing
Boost efficiency up to 93%
4 LED power display
Automatically detect phone insertion and removal
Double click the key to close the output, and click to open the output
TYPE-C supports single port input and output
Mobile phone charging current intelligent recognition DCP10. Intelligent load identification, automatic standby
Output overcurrent, overvoltage and short circuit protection
Input overvoltage,overcharge,overdischarge and overcurrent discharge protection
Package: 1 PCS

Type-C USB 5V 3.1A Boost Converter Step-Up Power Module IP5310 Mobile Power Bank Accessories with Switch LED Indicator

Description